Descriptions Of Control Sources; Midi Control Source List - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

exceptions to this rule, which have to do with global control source parameters. Globals affect
every note in each programÕs layer(s). Consequently they canÕt use local control sources as their
values, since local control sources affect each note independently.
Four of the control source parameters are always global: the Enable parameter on the LAYER
page (Program Editor), and the three control source parameters on the EFFECT page, (Program
Editor). When programming these parameters, youÕll see the Main Control Source list minus
the three special MIDI control sources, minus the following local control sources:
Note St
Key St
KeyNum
BKeyNum
AttVel
InvAVel
PPress
BPPress
RelVel
Bi-AVel
VTRIG1
VTRIG2
RandV1
RandV2
ASR1
LFO1
FUN1
FUN3
Loop St
PB Rate
AtkSt
Rel St
Finally, if youÕve turned on the Globals parameter on the COMMON page in the Program
Editor, the available values for GLFO2, and the values for GASR2Õs trigger will lack the local
control sources listed above, as well as the three special MIDI control sources and the FUN
constants. The available values for GFUN2 and GFUN4 will exclude the same list of local
control sources, but will include the FUN constants.

Descriptions of Control sources

This section is organized into two sets of descriptions: the MIDI Control Source list, and the
rest of the control sources. The numeral preceding the name of each control source can be
entered on the alphanumeric pad to select the control source directly (press ENTER after typing
the numeral).
Many of the MIDI control sources are assigned as default values for the control assignment
parameters on the MIDI mode XMIT page and the Setup Editor page. WeÕll indicate these
assignments as they appear, simply by mentioning that theyÕre the default control source for a
control assignment parameter.

MIDI Control Source List

With a few exceptions, the MIDI control sources correspond to the standard MIDI controller
numbers used by every MIDI device.
Control Sources
Descriptions of Control sources
25-3