Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 410

Control Sources
Descriptions of Control sources
128
0, 33
1
2
3
4
5
6
7
8
9
10
25-4
OFF
This value eliminates the effect of any control source parameter to which itÕs as-
signed.
MONO PRESSURE (MPress)
Many of the K2vxÕs factory programs are assigned to modify parameters such as
pitch, filter cutoff frequency, and depth control when MPress messages are re-
ceived. The mono pressure (Press) control assignment parameters in MIDI and Set-
up modes are set by default to transmit MPress messages when mono pressure
messages are received from a controller.
MIDI 01 (MWheel)
Many factory programs are assigned to respond to MWheel messages. The Mod
Whl parameter in MIDI and Setup modes is set by default to transmit MWheel.
MIDI 02 (Breath)
MIDI 03
MIDI 04 (Foot)
This is the standard MIDI controller number for continuous control foot pedals. ItÕs
the default value for the CPedal control assignment parameter, so a control pedal
on your MIDI controller which sends MIDI controller 04 messages will send MIDI
controller 04 messages to the K2vx by default.
MIDI 05 (PortTim)
This is the standard MIDI controller number for portamento time control. The
K2vx always responds to this control message. For any program that has porta-
mento turned on (on the COMMON page in the Program Editor), MIDI Portamen-
to Time messages received via MIDI will affect the rate of the programÕs
portamento.
MIDI 06 (Data)
MIDI 06 is the standard MIDI controller number for data entry. The Slider param-
eter on the MIDI mode XMIT page and in the Setup Editor is set by default to trans-
mit this message, and can be used to select programs and edit parameters on MIDI
slaves if your controller can send it.
MIDI 07 (Volume)
This is the standard MIDI controller number for volume. The Volume parameter
on the CHANLS page in MIDI mode will respond to MIDI controller 07 unless the
VolLock parameter is turned on.
MIDI 08 (Balance)
MIDI 09
MIDI 10 (Pan)
MIDI controller 10 is defined as Pan control. The Pan parameter on the CHANLS
page in MIDI mode will respond to MIDI controller 10 unless the PanLock param-
eter is turned on.