Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 327

9 Mix
F:Mix||||||||Start:0.000||||End:6.000|||
In:0.000|||Out:0.000|||Vol:0dB|||Cur:LIN
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
With this function you select a segment from Sample 2, and merge it with the selected segment
from Sample 1, beginning at the point you set with the Start parameter. This is equivalent to
mixing two audio signals through a mixing board. If the Sample 2 segment is longer than the
segment from the Start (S) to the End(E) of Sample 1, the resulting sample will be longer than
the original Sample 1.
Use the In and Out parameters to specify the length of time it takes Sample 2 to reach full
amplitude and to fade to silence. The Curve parameter selects the curve of the fades. The
available values are LIN, EXP, COS, EQL, and MIX. These curves are described at the end of the
section on DSP functions.
The Volume Adjust parameter will cut or boost the amplitude of Sample 2 from
-96 to 96 dB before merging.
If the sample rate of Sample 2 is different from that of Sample 1, the K2vx will alert you that the
sample rates differ. If you mix samples with different rates, youÕll hear a pitch shift in the mixed
sample. If you donÕt want this pitch shift, use the Resample function to match the sample rates
of the two samples before mixing.
Mixing Samples, Step-by-step
First, use the Start parameter of Sample 1 to set the point at which the mix will begin. Then
press the Samp2 soft button, and a page will appear enabling you to view and audition the list
of RAM samples. Select a sample with the Sample parameter, then use the cursor keys to select
the Start parameter. Turn the Alpha Wheel to set the beginning of the segment to be mixed in.
Repeat this process for the end position of the sample. You can audition the sample as youÕre
setting the range. Once the start and end points are set, press OK to return to the DSP page.
Then press Go to initiate the mix.
10 Insert
F:Insert|||||Start:0.000||||End:6.000|||
Xfade:0.000|||||Curve:LIN||||VolAdj:0dB|
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
Sampling and Sample Editing
Editing Samples
15-23