Entering Selection Criteria In The Multiple Object Selector - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

Disk Mode
The Multiple Object Selector Page
Clear
Set
Cancel Exits from the Multiple Object Selector page, with no action, and returns to the object

Entering Selection Criteria in the Multiple Object Selector

This section describes the operation of the selection modes provided on the Multiple Object
Selector page. These are accessed by scrolling the Select: parameter to different values, as
pictured above.
13-34
Multiple Object Selector page, set the selection range to Everything (or press the All
soft button), and press Toggle. This will return you to the object list display, with
everything that is not in use by the song now selected for deletion. All you would
have to do then is press OK and conÞrm the delete operation.
Clears the selection status of all objects within the speciÞed range. A basic example
of this would be if you wanted to save a Þle containing everything in RAM except
Programs. You could Þrst select all the objects with the Left/Right cursor button
double-press, and then go to the Multiple Object Selector. From there you could set
the selection range to be Programs in All Banks, and press Clear. The K2vx would
return to the object list display, with the only the desired objects selected for saving.
For each of the objects in the speciÞed range, select the object. For Example, to
select all Keymaps and Samples in the 300's bank for saving, you would Þrst set the
selection criteria to Type/Range, set the Type to Samples, set the Bank to 300's, and
press Set. Then, you would press Multi again, and just change the Type parameter to
Keymap, and press Set again. The desired range of objects would then be selected
and ready to proceed with saving.
function, with the previously displayed object list.