Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 137

2. Use the down arrow button to move the cursor to the Program Þeld.
When this Þeld is highlighted, type "52" then press the ENTER button. YouÕve now
assigned "Jazz Kit" to channel 1.
SongMode:MAIN||Events:186K|||STOPPED||||
CurSong:1|NewSong||||||||||||Tempo:120||
RecTrk|:1||||Vol:127|Pan:64||Mode|:Merge
Program: 52|Jazz|Kit||||||||| |Locat:||1:1
||||||||||||||||||||||||||||||||||||||||
Track||:R|-|-|-|-|-|-|-|-|-|-|-|-|-|-|-|
Channe l :1|2|3 | 4|5|6| 7 |8|9| 1 011121 3 141516
Record | |Play| | |Stop| | Erase | |MISC| | MIXER|
NOTE: If "52 Jazz Kit" appears in parentheses, it means that the current channel is not a drum channel.
You can either go to the Master page to change the drum channel, or assign the drums to a current drum
channel in Song mode.
3. Now use the up arrow button to highlight the RecTrk Þeld.
Change RecTrk to "2". You can use either the alpha wheel or the keypad.
4. Return to the Program Þeld, and set it to "80 Mix Bass".
SongMode:MAIN||Events:186K|||STOPPED||||
CurSong:1|NewSong||||||||||||Tempo:120||
RecTrk|:2||||Vol:127|Pan:64||Mode|:Merge
Program:80|Mix|Bass||||||||||Locat:||1:1
||||||||||||||||||||||||||||||||||||||||
Track||:-|R|-|-|-|-|-|-|-|-|-|-|-|-|-|-|
Channel:1|2|3|4|5|6|7|8|9|10111213141516
Record||Play|||Stop||Erase||MISC||MIXER|
Notice that the "R" on the Track line, which stands for "Record", has moved to track 2. Also
notice how each of the sixteen tracks has a default channel associated with it. You could
change this if you wanted to, but most people Þnd it easiest to associate track 1 with
channel 1, track 2 with channel 2, etc.
5. Repeat the above two steps to assign "97 Gospel Organ" to channel 3 and "46 Brt Saxy
Lead" to channel 4.
YouÕve now chosen the programs for your Þrst sequence. ItÕs important to realize, though,
that you have not recorded them yet. They will be there when you need them, but they
have not yet been included in a song. Also, donÕt forget that you can change the program
assignments any time before or after you record the song.
Record a Drum Loop
Our song will be based around a four measure drum loop that weÕll record now. Then, a little
later on, weÕll "unloop" the drum track and really start jamming.
The length of the drum loop is determined by the current endpoint, so weÕll start by recording 4
measures of silence to set the endpoint.
Song Mode
Getting Started with the Sequencer
12-3