Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 148

Song Mode
MAIN Page
The Chan parameter will be replaced with Setup. It is important to know how many channels,
and consequently how many tracks, are needed for recording a particular Setup. Each Setup
can have up to three Zones that can respond to your playing differently, depending on what
range of the keyboard is being played, or if certain velocity and/or controller values
determines when a particular Zone will respond. Be aware of the behavior of each Setup you
intend to record so that you can allocate the proper tracks and channels needed in your Song.
Volume (Vol)
You can set an initial volume level for the playback and recording of each track as a value
between 0 and 127. If the channel of the RecTrk (or the control channel, if RecTrk is set to Multi
or None) contains any recorded volume change (controller code 7), the change will be reßected
as the Vol parameterÕs value in real time.
Pan
You can set an initial pan position (the balance between the Left and Right audio channels) for
the playback and recording of each track as a value between 0 and 127. A value of 64 is center. If
the channel of the RecTrk or the control channel contains any panning data (controller code 10),
the Pan parameterÕs value is modiÞed in real time.
Mode
If Mode is set to Merge you will be able to overdub when recording on a track containing
previously recorded data. YouÕll usually want to set Mode to Merge when RecMode (on the
MISC page) is set to Loop. Otherwise, each time through the loop, the previously recorded
information will be erased.
If you set Mode to Erase, the previously recorded data on the record enabled track will be
replaced with the new data only during the Bars and Beats you are actually recording, and the
previously recorded data before and after the newly recorded Bars and Beats will be preserved.
Location (Locat)
The Bar and Beat displayed as the Locate value changes relative to current location of the Song
during playback and recording. You can set this to a negative Bar and Beat location to start
playback a set length of time before the beginning of the Song.
Whenever you set the Locate point, that location will be used as the return point when Stop is
pressed. Simply press Stop again to reset the Song to the top (1 : 1).
Mode Indicators (+ and x):
Mode Indicators only appear when there is pre-existing data on a track(s).
A plus sign (+) appears above the Track Status Indicator of a track set to record (R) when the
Mode parameter is set to Merge.
An (x) appears above the Track Status Indicator of a track set to Record (R) when the Mode
parameter is set to Erase.
Activity Indicators ( [)
A small square ([) above the Track Status Indicator of a track set to Play (P) or Mute (M) means
there is data contained on that track.
12-14
||||||||[|[|[|x|||||||||||||||||||||||||
Track||:P|P|M|R|-|-|-|-|-|-|-|-|-|-|-|-|
Channel:1|2|3|4|5|6|7|8|9|10111213141516