Setting The Date And Time; Section 2.6, "Setting The Date And Time - Novell ACCESS MANAGER 3.1 SP2 - ACCESS GATEWAY GUIDE 2010 Manual

Listening Port: Specifies the port on which to listen for requests from browsers. The listening
address and port combination must not match any combination you have configured for a
reverse proxy.
5 Configure the communication options between the tunnel and the Web servers by configuring
the following fields:
Connect Port: Specifies the port that the Access Gateway uses to communicate with the Web
server.
TCP Connect Options: Allows you to control how idle and unresponsive Web server
connections are handled and to optimize these processes for your network. See
"Configuring TCP Connect Options for Web Servers," on page
6 Specify a Web server to receive the traffic. In the Web Server List section, click New, specify
the IP address or DNS name of the Web server, then click OK.
At least one Web server must be specified in the list before you can save a tunnel configuration.
7 To save your changes to browser cache, click OK.
8 To apply your changes, click the Access Gateways link, then click Update > OK.

2.6 Setting the Date and Time

The Date & Time option lets you set the system time for the Access Gateway Appliance. To set the
date and time for the Linux or Windows Access Gateway Service, use the utilities supplied by the
operating system.
The time between the Identity Server and the Access Gateway must be either synchronized or set to
be within 1 minute of each other for trusted authentication to work.
To configure the date and time options:
1 (Access Gateway Appliance) In the Administration Console, click Devices > Access Gateways
> Edit > Date & Time.
2 (Conditional) If the Access Gateway belongs to a cluster of Access Gateways, select the Access
Gateway from the list displayed in the Cluster Member field. The modifications you make on
this page apply only to the selected Access Gateway.
90 Novell Access Manager 3.1 SP2 Access Gateway Guide
Section 1.6.2,
70.