Novell ACCESS MANAGER 3.1 SP2 - ACCESS GATEWAY GUIDE 2010 Manual page 89

2 Click New, enter a display name for the tunnel, then click OK.
3 Fill in the following fields:
Enable Tunnel: Specifies that the Access Gateway should set up a tunnel for all incoming
traffic. This option must be enabled to configure a tunnel.
Tunnel SSL Traffic Only: Allows you to configure the Access Gateway to tunnel only SSL
traffic. If this option is selected, the Access Gateway verifies that the address and port being
accessed are actually an SSL Web site. If verification fails, the service tears down the
connection. The SSL port number for the SSL tunnel is specified via the Listening Port and the
Connect Port.
Published DNS Name: Specify the DNS name you want the public to use to access your
tunnel or the virtual IP address assigned to the Access Gateway cluster by the L4 switch. If you
specify a DNS name, the DNS name must resolve to the IP address you set up as the listening
address for the tunnel.
4 Configure the communication options between the browsers and the tunnel by configuring the
following fields:
Cluster Member: (Available only if the Access Gateway is a member of a cluster.) Select the
server you want to configure from the list of servers. The Listening Address(es) modifications
apply to the selected server. Any other modifications apply to all servers in the cluster.
Listening Address(es): Displays a list of available IP addresses. If the Access Gateway has
only one IP address, only one is displayed. If it has multiple addresses, you can select one or
more addresses to enable. You must enable at least one address by selecting its check box.
TCP Listen Options: Provides additional options for configuring how requests are handled.
See Section 1.6.1, "Configuring TCP Listen Options for Clients," on page
server must be configured before you can modify these options.
69. At least one Web
Server Configuration Settings 89