Access Gateway Maintenance; Access Gateway Appliance Logs; Configuring Log Levels; Section 4.1, "Access Gateway Appliance Logs - Novell ACCESS MANAGER 3.1 SP2 - ACCESS GATEWAY GUIDE 2010 Manual

Access Gateway Maintenance

4
Section 4.1, "Access Gateway Appliance Logs," on page 123
Section 4.2, "Access Gateway Service Logs," on page 126
Section 4.3, "Configuring Logging for a Proxy Service," on page 131
Section 4.4, "Viewing Access Gateway Statistics," on page 140
Section 4.5, "Viewing Cluster Statistics," on page 150
Section 4.6, "Monitoring Access Gateway Alerts," on page 150
Section 4.7, "Enabling Access Gateway Audit Events," on page 156
Section 4.8, "Managing Server Health," on page 157
Section 4.9, "Viewing the Command Status of the Access Gateway," on page 163
Section 4.10, "Tuning the Access Gateway for Performance," on page 165

4.1 Access Gateway Appliance Logs

This section contains the following information about the Access Gateway Appliance logs:
Section 4.1.1, "Configuring Log Levels," on page 123
Section 4.1.2, "Interpreting Log Messages," on page 124
Section 4.1.3, "Configuring Logging of SOAP Messages and HTTP Headers," on page 125

4.1.1 Configuring Log Levels

You can use the following procedure to set the level of information logged to the
in the directory.
/var/log
1 On the Linux Access Gateway Appliance, log in as
2 At the command prompt, enter the following command:
nash
3 At the shell prompt, enter the following command:
nash
configure .current
4 To change the log level, enter the following command:
log-conf log-level <log level>
Replace
<log level>
Level
LOG_EMERG
LOG_ALERT
LOG_CRIT
with the new log level that you want to set.
Description
Sends only messages that render the system unusable, if they are not
resolved.
Sends only messages that require immediate action.
Sends only messages about critical situations.
ics_dyn.log
.
root
Access Gateway Maintenance
4
file
123