Fluke 5500A Operator's Manual page 356

5500A
Operator Manual
SCOPE
Programs the 5500A-SC oscilloscope calibration hardware, if installed. The instrument
settings are determined by this command's parameter. Once in SCOPE mode, use the
OUT command to program new output.
OPER, STBY, *OPC, *OPC?, and *WAI all operate as described in Chapter 6. The state
of the oscilloscope's output while in SCOPE mode is reflected by the bit in the ISR that
is assigned to SETTLED.
The FUNC? query returns SDCV, SACV, LEVSINE, MARKER, EDGE, and WAVEGEN for
the corresponding oscilloscope modes.
Parameters: OFF
Example:
8-84
x x
IEEE-488 RS-232
VOLT
EDGE
LEVSINE
MARKER
WAVEGEN
SCOPE VOLT;
SCOPE VOLT;
SCOPE EDGE;
SCOPE LEVSINE; OUT 1V, 20 kHz
SCOPE MARKER;
SCOPE WAVEGEN; OUT 1V, 1 kHz
x x
Sequential Overlapped
Turns the oscilloscope hardware off. Programs 0 V,
0 Hz, output at the NORMAL terminals, standby.
Oscilloscope's ac and dc voltage mode.
Programs 20 mV peak-to-peak, 1 kHz, output at the
SCOPE BNC, output impedance 1 M , standby if
from OFF or previously in standby.
Oscilloscope Edge mode. Programs 25 mV peak-to-
peak, 1 MHz, output at the SCOPE BNC, standby if
from OFF or previously in standby.
Oscilloscope-leveled sine mode. Programs 30 mV
peak-to-peak, 50 kHz, output at the SCOPE BNC,
standby if from OFF or previously in standby.
Oscilloscope Marker mode. Programs the period to
1 ms, output at the SCOPE BNC, standby if from
OFF or previously in standby.
Oscilloscope Wavegen mode. Programs 20 mV
peak-to-peak, square wave, 1 kHz, no offset, output
impedance 1 M , standby if from OFF or
previously in standby.
OUT -2V, 0 Hz
OUT 4V, 1 kHz
OUT 0.5V, 5 kHz
OUT 2 MS
x
Coupled
(dc voltage, -2 V)
(ac voltage, 4 V peak-to-
peak, 1 kHz.)
(Edge, 0.5 V peak-to-peak,
5 kHz.)
(Leveled sine wave, 2 V
peak-to-peak, 20 kHz.)
(Marker, period of 2 ms.)
(Wave Generator, 1 V
peak-to-peak, 1 kHz.)