Pocket Finishing (Cycle) - HEIDENHAIN ITNC 530 User Manual

POCKET FINISHING (Cycle 212)
1 The TNC automatically moves the tool in the tool axis to set-up
clearance, or—if programmed—to the 2nd set-up clearance, and
subsequently to the center of the pocket.
2 From the pocket center, the tool moves in the working plane to the
starting point for machining. The TNC takes the allowance and tool
radius into account for calculating the starting point. If necessary,
the TNC penetrates at the pocket center.
3 If the tool is at the 2nd set-up clearance, it moves in rapid traverse
FMAX to set-up clearance, and from there advances to the first
plunging depth at the feed rate for plunging.
4 The tool then moves tangentially to the contour of the finished part
and, using climb milling, machines one revolution.
5 After this, the tool departs the contour tangentially and returns to
the starting point in the working plane.
6 This process (3 to 5) is repeated until the programmed depth is
reached.
7 At the end of the cycle, the TNC retracts the tool in rapid traverse
to set-up clearance, or—if programmed—to the 2nd set-up
clearance, and finally to the center of the pocket (end position =
starting position).
Before programming, note the following:
The TNC automatically pre-positions the tool in the tool
axis and working plane.
The algebraic sign for the cycle parameter DEPTH
determines the working direction. If you program
DEPTH = 0, the cycle will not be executed.
If you want to clear and finish the pocket with the same
tool, use a center-cut end mill (ISO 1641) and enter a low
feed rate for plunging.
Minimum size of the pocket: 3 times the tool radius.
Enter in MP7441 bit 2 whether the TNC should output an
error message (bit 2=1) or not (bit 2=0) if a positive depth
is entered.
Danger of collision!
Keep in mind that the TNC reverses the calculation for pre-
positioning when a positive depth is entered. This
means that the tool moves at rapid traverse in the tool axis
at safety clearance below the workpiece surface!
HEIDENHAIN iTNC 530
Q206
Z
Q200
Q203
Q202
Y
Q218
Q217
Q216
Q204
Q201
X
Q207
X
Q221
373