Magnifying Details - HEIDENHAIN ITNC 530 User Manual

Magnifying details

You can magnify details in all display modes in the Test Run mode and
a program run mode.
The graphic simulation or the program run, respectively, must first
have been stopped. A detail magnification is always effective in all
display modes.
Changing the detail magnification
The soft keys are listed in the table.
Interrupt the graphic simulation, if necessary.
Shift the soft-key row in the Test Run mode, or in a program run
mode, respectively, until the soft key for detail enlargement
appears.
Select the functions for section magnification.
Press the corresponding soft key to select the
workpiece surface (see table below).
To reduce or magnify the blank form, press and hold
the MINUS or PLUS soft key, respectively.
Restart the test run or program run by pressing the
START soft key (RESET + START returns the
workpiece blank to its original state).
Function
Select the left/right workpiece surface
Select the front/back workpiece surface
Select the top/bottom workpiece surface
Shift the sectional plane to reduce or
magnify the blank form
Select the isolated detail
HEIDENHAIN iTNC 530
Soft keys
589