Mod Function; Changing The Settings; Selecting The Mod Functions; Exiting The Mod Functions - HEIDENHAIN ITNC 530 User Manual

13.1 MOD Function

The MOD functions provide additional input possibilities and displays.
The available MOD functions depend on the selected operating mode.

Selecting the MOD functions

Call the operating mode in which you wish to change the MOD
functions.
To select the MOD functions, press the MOD key.
The figures at right show typical screen menus in
Programming and Editing (figure at upper right), Test
Run (figure at lower right) and in a machine operating
mode (see figure on next page).

Changing the settings

Select the desired MOD function in the displayed menu with the
arrow keys.
There are three possibilities for changing a setting, depending on the
function selected:
Enter a numerical value directly, e.g. when determining traverse
range limit.
Change a setting by pressing the ENT key, e.g. when setting
program input.
Change a setting via a selection window. If more than one possibility
is available for a particular setting, you can superimpose a window
listing all of the given possibilities by pressing the GOTO key. Select
the desired setting directly by pressing the corresponding numerical
key (to the left of the colon), or by using the arrow keys and then
confirming with ENT. If you don't want to change the setting, close
the window again with END.

Exiting the MOD functions

Close the MOD functions with the END key or soft key.
608 13 MOD Functions