Unit 123 Contour Pocket Floor Finishing - HEIDENHAIN ITNC 530 - PILOT SMART NC Manual

Unit 123 Contour Pocket Floor Finishing

With the floor finishing unit you can finish the floor of a contour pocket
that has been roughed-out with unit 122.
Always run the floor finishing operation before side finishing!
Parameters on the overview form:
U
T: Tool number or name (switchable via soft key)
U S: Spindle speed [rpm] or cutting speed [m/min or ipm]
U F: Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]
U F: Feed rate for milling [mm/min] or FU [mm/rev] or FZ [mm/tooth]
Additional parameters on the tool detail form:
U DL: Delta length for tool T
U DR: Delta radius for tool T
U
DR2: Delta radius 2 (corner radius) for tool T
U M function: Any miscellaneous function M
U Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Globally effective parameters on the global data detail form:
U Retraction feed rate
110