Coordinates After Probing During Program Run - HEIDENHAIN ITNC 530 User Manual

Coordinates after probing during program run

The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates are referenced to the
datum that is currently active in the Manual operating mode.
The length and radius of the probe tip are not compensated in these
coordinates.
Coordinate axis
X axis
Y axis
Z axis
IVth axis
dependent on MP100
Vth axis
dependent on MP100
Deviation between actual value and nominal
value during automatic tool measurement with
the TT 130
Actual-nominal deviation
Tool length
Tool radius
Tilting the working plane with mathematical
angles: Rotary axis coordinates calculated by the
TNC
coordinates
A axis
B axis
C axis
570
Parameter value
Q115
Q116
Q117
Q118
Q119
Parameter value
Q115
Q116
Parameter value
Q120
Q121
Q122
11 Programming: Q Parameters