Single-Digit Edit Mode - Omron MX2 User Manual

Using the Front Panel Keypad
2-5-6

Single-Digit Edit Mode

56
If a target function code or data is far from current data, using the single-digit
edit mode makes it quicker. Pressing the up key and down key at the same
time leads you to go into the digit-to-digit changing mode.
F001
(A)
F001
A001
1st digit will be
blinking. Use up/down
keys to change the
value of the digit.
50.00
(B)
50.00
60.00
1st digit will be blinking.
Use up/down keys to
change the value of the
digit.
Note When pressing
the lowest digit. ((A) and (B) in above figure.)
Note When pressing up key and down key at the same time in single-digit edit
mode, the single-digit edit mode is disabled and goes back to normal mode.
While in Single-digit edit mode (single digit is blinking):
: Move cursor to right or set the func.code/data (lowest digit only)
: Move cursor to left.
F001
F101
2nd digit will be 3rd digit will be
blinking. Use up/down blinking. Use up/down
keys to change the keys to change the
value of the digit. value of the digit.
If not existing codes are selected, the data sill not move to the function
code but blinking digit will move again to the left end digit.
50.00
51.00
2nd digit will be blinking. 3rd digit will be blinking.
Use up/down keys to Use up/down keys to
change the value of the change the value of the
digit. digit.
with cursor on the highest digit, the cursor will jump to
Section 2-5
(A)
F001 F001
F011 F002
4th digit will be blinking.
Use up/down keys to
change the value of the
digit.
(B)
50.00 50.00
50.10 50.01
4th digit will be blinking.
Use up/down keys to
change the value of the
digit.