Digital Input Configuration For Bit Operation - Omron MX2 User Manual

"A" Group: Standard Functions
(motor running). If it is necessary to check the value of
D001
please monitor instead of
There are two ways to program the speeds into the registers
1. Standard keypad programming
2. Programming using the CF switches. Set the speed following these steps:
a) Turn the Run command OFF (Stop Mode).
b) Turn inputs ON to select desired Multi-speed. Display the value of
on the digital operator.
c) Set the desired output frequency by pressing the
d) Press the key once to store the set frequency. When this occurs,
F001
indicates the output frequency of Multi-speed n.
e) Press the
the set frequency.
f) Repeat operations in 2. a) to 2. e) to set the frequency of other Multi-
speeds.

Digital Input configuration for bit operation

Option Terminal
Code Symbol
32~38
SF1~SF2 Multistage
Speed ~ Bit
Operation
C001~C007
Valid for inputs:
F001, A001=02, A020 to A035
Required settings:
Notes:
• When programming the multi-speed settings, be sure to press the
time and then set the next multi-speed setting. Note that when the key is not
pressed, no data will be set.
• When a multi-speed setting more than 50Hz (60 Hz) is to be set, it is necessary to
program the maximum frequency A004 high enough to allow that speed
Jog Frequency - The jog speed setting is used whenever the Jog command
is active. The jog speed setting range is arbitrarily limited to 9.99 Hz, to pro-
vide safety during manual operation. The acceleration to the jog frequency is
F001
.
key once to confirm that the indication is the same as
Function State
Name
ON Makes multistage speed by combi-
nation of the inputs.
OFF
Section 3-5
F00
1 during Run Mode,
A020 A035
to :
F001
and keys.
Description
key each
77