Omron CP - PROGRAMMING MANUAL 05-2007 Programming Manual page 149

Sequence Output Instructions
Variations
Applicable Program Areas
Operand Specifications
Description
116
Variations Executed Each Cycle for ON Condition
Executed Once for Upward Differentiation
Executed Once for Downward Differentiation
Immediate Refreshing Specification
Block program areas
Not allowed OK
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
Indirect DM addresses
in binary
Indirect DM addresses
in BCD
Constants
Data Registers
Index Registers
Indirect addressing
using Index Registers
When S turns ON, the designated bit will go ON and stay ON until reset,
regardless of whether S stays ON or goes OFF. When R turns ON, the desig-
nated bit will go OFF. The relationship between execution conditions and
KEEP(011) bit status is shown below.
Set
Reset
ON
S execution condition
OFF
ON
R execution condition
OFF
ON
Status of C
OFF
Step program areas Subroutines
OK
CIO 0.00 to CIO 6143.15
W0.00 to W511.15
H0.00 to H511.15
A448.00 to A959.15
---
---
---
---
---
---
---
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047, IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to ,IR15+(++)
,–(– –) IR0 to, –(– –) IR15
Section 3-3
KEEP(011)
Not supported
Not supported
!KEEP(011)
Interrupt tasks
OK
B