Adding A Windows Nt 4.0 Driver On An Nt 3.51 Server - Tektronix Phaser 740 Setup Manual

7
Windows NT

Adding a Windows NT 4.0 driver on an NT 3.51 server

46
PhaserShare Networking
Name the printer and set up sharing
1.
Type the printer's name; this can be any name you want. If the
Windows-based applications are to use this printer as the default
printer, click the appropriate box. Click Next.
2.
If this printer is to be shared on a network, click Shared and click all
applicable platforms that may be printing to this printer. If the printer
is a local printer only, click Not shared. Click Next.
Windows NT creates the printer
1.
If you want Windows NT to print a test page after installing the printer
driver, click Yes (recommended). If you do not want the Windows NT
test page, click No. When finished, click Finish.
2.
At this point, Windows NT is ready to create the printer. You may need
the original Windows NT distribution CD-ROM to complete this step.
Once the Windows NT medium is installed, type the path name to the
files requested. The files are usually in the I386 directory for
Intel-based Windows NT servers. Click OK.
3.
If you chose to have a test page printed in Step 1, check to see if it
printed. If the test page printed, click OK.
N
O T E
For proper installation, use the latest Windows NT 3.51 drivers and
Windows NT 4.0 drivers, available from the Tektronix web site:
www.tek.com/Color_Printers/support/software.html
The following procedure describes how to set up the Windows NT 3.51 server to
automatically load a Windows NT 4.0 driver on a Windows NT 4.0 client.
N
O T E
You must have Administrator access on the Windows NT 3.51 server.