Tektronix Phaser 740 Setup Manual page 60

8
Setting the Printer's IP Addressing Parameters
54
PhaserShare Networking
5.
To set the network mask:
a.
Press ----> until Network Mask is displayed.
b.
Press Select; the front panel displays the network mask.
c.
Use + and ----> as described in Steps 4d through 4f to set the
network mask.
d.
When the network mask is set, use Set and Confirm as described
in Steps 4g and 4h to enter the network mask into the printer.
6.
To set the gateway address:
a.
Press ----> until Gateway Address is displayed.
b.
Press Select; the front panel displays the gateway address.
c.
Use + and ----> as described in Steps 4d through 4f to set the
gateway address.
d.
When the gateway address is set, use Set and Confirm as
described in Steps 4g and 4h to enter the gateway address into the
printer.
7.
The printer calculates the broadcast address based on the IP address
and the network mask. However, the broadcast address can be viewed
and set using the following procedure:
a.
Press ----> until Broadcast Address is displayed.
b.
Press Select; the front panel displays the broadcast address.
c.
Use + and ----> as described in Steps 4d through 4f to set the
broadcast address.
d.
When the broadcast address is set, use Set and Confirm as
described in Steps 4g and 4h to enter the broadcast address into the
printer.