Setting Ip Parameters: Phaser 740 Printer Front Panel - Tektronix Phaser 740 Setup Manual

Setting IP parameters: Phaser 740 printer front panel

N
O T E
When you set the IP addressing parameters from the front panel, the selections
for DHCP/BOOTP and RARP are automatically set to Disabled.
1.
Press Menu; the front panel displays Help Pages.
2.
Press ----> or <---- until the front panel displays Network
Settings.
3.
Press Menu until the front panel displays TCP/IP.
4.
To set the IP address:
a.
Press Menu again; the front panel displays Interface.
b.
Press ----> to display TCP/IP Address.
c.
Press Select to display the IP address. For example:
192.2.194.101
+ ---->
N
O T E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see "Setting IP parameters: RARP or
BOOTP" on page 61).
d.
Press + to set the left-most digit of the address.
e.
Press ----> to advance to the next digit. Press + to set this digit.
f.
Use ----> and + as described in Step e to set the remaining digits.
g.
When the address is correctly set, press Set to enter your settings
into the printer; the front panel displays:
Confirm Selection
Confirm
h.
Press Confirm; the front panel briefly displays Selected, then
returns to TCP/IP Address. The IP address is now set in the
printer.
Setting the Printer's IP Addressing Parameters
Set
8
53
Setup Guide