Tektronix Phaser 740 Setup Manual page 38

5
TCP/IP Configuration (UNIX)
Assigning print queues with PhaserPrint for UNIX
Required remote printer queue names
Using PostScript utility files to control printer features from queues
32
PhaserShare Networking
For UNIX environments, Tektronix offers PhaserPrint for UNIX software, which
provides fast raster printing and a graphical user interface with push-button
control of printer features. For more information on PhaserPrint software, see
the PhaserShare Networking Manual on the printer's CD-ROM.
If you want to print using PhaserPrint for UNIX software, you must use
PhaserPrint software to configure your host. Refer to the PhaserPrint for UNIX
user manual or the instructions provided with the PhaserPrint for UNIX
CD-ROM for configuration information. PostScript and PDF versions of the
manual are available from the Tektronix ftp site:
ftp.tek.com/cpid/UNIX/phaserprint2.1/demo/MANUALS
The printer's internal LPR queue uses the BSD protocol; its known queues are
listed in the following table. These are the only remote queue names that the
printer recognizes. If you use another name, the printer automatically defaults
to AUTO.
Queue name Language
PS PostScript
HPGL HP-GL (Hewlett-Packard Graphics Language)
PCL PCL (Printer Control Language)
AUTO Automatic Language Selection (the printer automatically senses
the language of the print job and processes it accordingly)
N
O T E
Your printer model may not support all languages listed in the table. See your
printer's user documentation for information on the supported languages.
As you set up a spool queue, you can use the PostScript utility files provided
with your printer's software to control printer features (for example, selecting
upper or lower paper trays, or selecting print quality modes). See your printer's
user documentation for more information on these utility files.