Tektronix Phaser 740 Setup Manual page 65

d.
Press Increment to set the left-most digit of the address.
e.
Press Shift to advance to the next digit. Press Increment to set
this digit.
f.
Use Shift and Increment as described in Step e to set the
remaining digits.
g.
When the address is correctly set, press Select to enter your
settings into the printer; the front panel displays:
Confirm Selection
Confirm
h.
Press Confirm; the front panel briefly displays Selected, then
displays the IP address again. The IP address is now set in the
printer.
i.
Press Exit to return to the menu of IP addressing parameters.
5.
To set the network mask:
a.
Press ----> until Network Mask is displayed.
b.
Press Menu; the front panel displays the network mask.
c.
Use Increment and Shift as described in Step 4d through 4f to
set the network mask.
d.
When the network mask is set, use Select and Confirm as
described in Steps 4g and 4h to enter the network mask into the
printer.
e.
Press Exit to return to the menu of IP addressing parameters.
6.
To set the gateway address:
a.
Press ----> until Gateway Address is displayed.
b. Press Menu; the front panel displays the gateway address.
c. Use Increment and Shift as described in 4d through 4f to set
the gateway address.
d.
When the gateway address is set, use Select and Confirm as
described in Steps 4g and 4h to enter the gateway address into the
printer.
Setting the Printer's IP Addressing Parameters
Setup Guide
8
59