Adding A Port For A New Printer - Tektronix Phaser 740 Setup Manual

6
Windows 95 and Windows 98: PhaserPort Software

Adding a port for a new printer

40
PhaserShare Networking
e.
If desired, change the printer's name (the name that will show in
your Printers window). You can also choose to make this printer
your default Windows printer. Click Finish.
f.
If you are prompted to send a test page to the printer, choose No.
Click Finish.
5.
Complete the installation.
a.
In the Installation Completed dialog, click Finish.
b.
When prompted, finish the setup by registering your printer and
restarting your computer.
The following topics provide instructions for using PhaserPort after the initial
installation:
The next topic: "Adding a port for a new printer"
"Adding a port to an existing printer" on page 41
"Changing a port's IP address" on page 42
Use this procedure to install a new printer and add a port for it.
1.
Start the Add Printer Wizard:
a.
From the Start menu, select Settings, then click Printers.
b.
From the Printers window, open Add Printer.
2.
Use the Add Printer Wizard to install the printer. When prompted,
make the following choices:
When prompted to specify how the printer is attached, chose Local
Printer.
Chose LPT1 as the connection port.
If you are prompted to send a test page to the printer, choose No.
3.
When you are finished with Add Printer Wizard, follow the directions
in the next topic, "Adding a port to an existing printer".