Tcp/Ip Configuration (Unix); Adding The Printer To The Host Table; Assigning A Print Queue To The Printer - Tektronix Phaser 740 Setup Manual

Chapter
5

Adding the printer to the host table

Assigning a print queue to the printer

TCP/IP Configuration
(UNIX)
Add the printer's name to the host table and assign an IP address to the printer's
name. Depending on your host system, you may do this one of three ways:
Use NIS (Name Information Server, formerly Yellow Pages).
Use DNS (Domain Name Server).
Edit a file (for example, /etc/hosts). For an example, see "Example
installation for a typical BSD UNIX system" on page 33.
For BSD systems, edit the /etc/printcap file and add a spool directory
(for example, to /usr/spool/lpd).
For System V hosts, configure the queue as a remote BSD print queue
(support for TCP/IP LPR is required). Specific instructions for the
following System V hosts are provided in the PhaserShare Networking
Manual on the printer's CD-ROM:
Sun Solaris
SGI IRIX 5.3 and 6.x
IBM AIX 3.x and 4.x
Hewlett-Packard HP-UX 9.x and 10.x.
N
O T E
Some UNIX hosts report an error when you configure a print queue that is not
currently on the network; ignore this message.
31
Setup Guide