Tektronix Phaser 740 Setup Manual page 62

8
Setting the Printer's IP Addressing Parameters
56
PhaserShare Networking
c.
Press Menu to display the IP address. For example:
IP Address
192.2.194.101
N
O T E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see "Setting IP parameters: RARP or
BOOTP" on page 61).
d.
Press to set the left-most digit of the address.
e.
Press to advance to the next digit. Press
f.
Use and
g. When the address is correctly set, press Select; the front panel
displays the IP Address with a Confirm button.
h.
Press Confirm; the front panel briefly displays Selected, then
displays the IP address again. The IP address is now set in the
printer.
i. ; the front panel displays:
Press
TCP/IP
IP Address
6.
To set the network mask:
a.
Press until Network Mask is displayed.
b.
Press Menu; the front panel displays the network mask.
c.
Use and
network mask.
d.
When the network mask is set, use Select and Confirm as
described in Steps 4g and 4h to enter the network mask into the
printer.
e. ; the front panel displays:
Press
TCP/IP
Network Mask
Select
as described in Step e to set the remaining digits.
Menu
as described in Steps 4d through 4f to set the
Menu
to set this digit.