Ring Speed Jumper - Tektronix Phaser 740 Setup Manual

Ring speed jumper

The Token Ring card is equipped with a single three-pin jumper to set the ring
speed. There are two settings: 4 Mbps and 16 Mbps.
N
O T E
If you received your printer with the Token Ring card already installed, you must
turn off the printer and remove the card before you change the jumper setting.
The following illustration shows a top view of the card and the location of the
jumper.
1. Rear panel
2. Jumper
Connecting Your Printer to a Network
1
2
16 Mbps
Setup Guide
2
4 Mbps
9789-03
11