Tektronix Phaser 740 Setup Manual page 66

8
Setting the Printer's IP Addressing Parameters
60
PhaserShare Networking
7.
The printer calculates the broadcast address based on the IP address
and the network mask. In most cases, this calculated value is correct
and there is no need to set the broadcast address. However, the
broadcast address can be viewed and set using the following
procedure:
a.
Press ----> until Broadcast Address is displayed.
b.
Press Menu; the front panel displays the broadcast address.
c.
Use Increment and Shift as described in 4d through 4f to set
the broadcast address.
d.
When the broadcast address is set, use Select and Confirm as
described in Steps 4g and 4h to enter the broadcast address into the
printer.
8.
Return the printer to normal operation.
a.
Press Exit until the front panel displays Network Settings.
b.
Press Exit again.
If you have changed any parameters that require a printer reset
to take effect, you will be prompted to reset the printer. If you
press Reset, the printer resets. If you press Resume, the front
panel displays Network Settings. Press Exit; the printer
returns to normal operation, but the changes you have made
will not take effect until the next time the printer is reset.
If you have not changed any parameters that require a printer
reset to take effect, the front panel displays Ready.