Table of Contents
Advertisement
5 After storing the autodial number, hang up using the KP9X hang-up sequence.
Dialing an Autodial Number Stored in the TIF-951 / TIF-2000
Tap the PHONE key to activate dialing mode.
1
Tap "down" on the TIF talk key to latch it in the on position.
2
Tap CLR followed by the autodial number (01, 02, etc.).
3
4
When finished dialing, click the PHONE key again to exit dialing mode.
Hang up using theKP9X hang-up sequence.
5
DIALING AND HANGING UP USING THE KP-632 DIALING
MENU
The dialing menu will only activate when talking to an intercom port that has the "Port is TIF"
check box activated in ADAMedit. (In ADAMedit, click the "KP" button to access the
Keypanels/Ports screen, then select the port where the TIF-951 / TIF-2000 is connected, then
click the "Edit" button, then click the "Advanced" tab. Place a check mark next to "Port is TIF".
Remember to send this change to the intercom system.)
Manual Dialing
Turn on the TIF talk key.
1
Tap the PGM key.
2
headset.
To hang up at any time after this point: tap the BACK key.
Note
While using the phone, any incoming intercom calls to the Call waiting window will go into the
Note
call waiting stack. The caller names will not be displayed, but the Call waiting LED will flash red.
You may either hang up the phone and answer the intercom call, or continue with the phone call
and answer the intercom call afterward.
3 Dial the phone number. Digits appear in the Call waiting window as you dial. Dialing tones are
audible in the speaker or headset.
4 If the far end answers, begin your conversation.
After the far end answers, you may dial additional digits (to retrieve voice mail, log onto an
Note
automated answering system, etc.).
5 If there is no answer, or to hang up when finished talking, tap the BACK key.
displays. Tap PGM to hang up.
Occasionally, you may receive intercom caller names in the Call waiting window while you are
Note
talking on the phone. In this case, the dialing menu options will be cleared from the Call waiting
window, and the
use the "KP9X Keypad Hang-up Sequence".
Redial
Turn on the TIF talk key.
Tap the ↓↓ key until
Tap PGM.
displays in the Call waiting window.
ManualDial
displays, and the dial tone should be audible in your speaker or
Dial#?
option won't be available. Instead of trying to reenter the menu system,
Hang up
displays in the Call waiting window.
ManualDial
displays.
Redial
will display, then tap PGM.
Hang up
Hang up
4-3
Advertisement
Chapters
Table of Contents
