Mixing; Service Menu, Hdst Sel - RTS EKP-632 User Manual

Tap PGM.
2
3
Meter: Mic
Meter: Mic
Meter: Mtx
Meter: Aux1
Meter Aux 2
Tap PGM.
4
The Vol. bar graph is now monitoring the selected audio source.
5
Tap CLR to exit metering, or allow the metering function to timeout after about 1 minute.
6

Mixing

Mixing lets you route selected audio signals to the intercom system, to the speaker, or to the left
or right headphone when using a headset. By default, the microphone signal is routed to the
matrix, and the matrix signal is routed to the speaker and to the left and right headphones.
Tap PGM.
1
2
To Matrix
To Matrix
Speaker
Left Hdst
Right Hdst
Tap PGM.
3
→
4
Mic
routed to the destination that you selected in step 2. To toggle the selection, press PGM. You
can also press ↓↓ or −− .to display and toggle any of the following items:
Mic
Matrix
Aux 1
Aux 2
5 Tap CLR to exit when you are finished changing the mixing selections.
Run Service Menu, Save Cfg, to store any mixing changes.
6

Service Menu, Hdst Sel

This item lets you select either the front panel headset jack or the headset connector on the
optional rear connector module. By default, the front panel jack is selected.
1. Select
2. →
Default
3. To change the selection, press ↓↓ .
4.
External
5. Tap PGM.
6. →
External
7. Tap CLR to exit.
8. Run Service Menu, Save Cfg, to store the new setting.
6-12
K P - 6 3 2 U s e r M a n u a l
displays. Press ↓↓ or −− .to display any of the following items:
displays. Press ↓↓ or −− .to display any of the following items:
or displays. If an arrow displays, this indicates that the mic signal is currently being
Mic
then tap PGM.
Hdst Sel,
displays. The arrow indicates the default front panel jack is selected.
displays.
displays. This indicates that the rear panel jack is now selected.