Specifications; Digital; Connections; Dip Switches - RTS EKP-632 User Manual

Specifications

Digital

Compression Audio Bit Rate
G.711 64k
G.729AB 8k
G.723 5.3k/6.3k
* Data depends on CODEC selection
Note: The Playout Delay and Bandwidth depend on the configured amount of audio per packet.

Connections

- RJ-45 Ethernet via backcard
- 14-pin KP Compatible Expansion Connector
Pin 1 ............................................................................................. 5 Volt Analog
Pin 2 ............................................................................................. -12 Volt
Pin 3 ............................................................................................. +12 Volt
Pin 4 ............................................................................................. 5 Volt Digital
Pin 5 ............................................................................................. Analog GND
Pin 6 ............................................................................................. Digital GND
Pin 7 ............................................................................................. To Matrix Audio L
Pin 8 ............................................................................................. NC
Pin 9 ............................................................................................. From Matrix Audio L
Pin 10 ........................................................................................... RS485L
Pin 11 ........................................................................................... From Matrix Audio H
Pin 12 ........................................................................................... NC
Pin 13 ........................................................................................... To Matrix Audio H
Pin 14 ........................................................................................... RS485H
Power .......................................................................................... Powered internally from
Physical ....................................................................................... 2.5"W x 5.75"L

Dip Switches

Switch 1
: Reserved
Switch 2
: Disable Telnet Shell
Default Setting:
Description:
Switch 3: Enable Boot Downloader
Default Setting:
Description:
Switch 4: Debug Only!
Default Setting:
Description:
8
Coding Delay
125 µ s
10ms
30ms
OFF (Telnet Enabled)
The Telnet shell allows you to access configuration options through the use of
Telnet. When DIP switch 2 is OFF, you can use Telnet to access configuration
options on the RVON-1 card. Turn DIP switch 2 ON to disable the Telnet shell.
OFF (Boot Downloader Disabled)
The purpose of the boot downloader is to allow you to recover from having your
main application image corrupted (either by bad flash programming or by down-
loading an invalid image). Turn DIP switch 3 ON to enable the boot downloader.
OFF
DIP switch 4 should always be left in the OFF position. It is reserved for debug-
ging and can have unintended consequences.
Playout Delay IP Bandwidth
20-60ms 160-224 kbps
20-120ms 32-112 kbps
60-120ms 29-45 kbps
keypanel motherboard
(63.5mm W X 146.05mm L)
RVON-1 User Manual