Address Setting For Adam; Connections; Exp. Connectors; Frame Connector - RTS EKP-632 User Manual

Address Setting for ADAM

Each Audio I/O card contains 1 group of 8 intercom ports. Determine the address setting from
Figure 2.1. To use the table, locate the intercom port number to which the KP-632 will be
connected. Then, read across to the "Address" column to find the Address number. Set the KP-
632 Address switch to this number. Note: settings 0, and 9 through F are not used.

Connections

EXP. Connectors

Connect from the Exp. connector on the back of the KP-632 to the Expansion 1 connector of an
optional EKP-632 Expansion Panel. Use the interconnect cable supplied with the Expansion
Panel.

Frame Connector

Use either of the Frame connectors (but not both) to connect to an intercom port of the intercom
system. The intercom port you connect to should agree with the address that you set previously.
Cable wiring diagrams are shown in Figure 2.2 and Figure 2.3.
Figure 2.2 DE9S Intercom Cable Wiring
2-5