Service Menu, LCD Bright
This item allows you to adjust the brightness of the LCD backlighting so that the unit's display
can be viewed in a wide range of ambient room light conditions.The
overall LCD brightness level including the right LCD on the KP-632. The
the left LCD on the KP-632. The
brightness levels are balanced at the factory before shipping, thus under normal circumstances the
selection should be used.
All
Select
then tap PGM.
1
LCD Bright,
displays. To change the selection, press ↓↓ or −− to move through the
2
All
selections.
EXP1
Tap PGM.
3
If the
selection was made proceed to step 6. If
4
All
was selected press ↓↓ or −− to move through the
Tap PGM.
5
displays where x is a number between 5 and 100.
6
Value: X
To change the selection, press ↓↓ or −−. The higher the number, the brighter the backlight.
7
Tap PGM.
8
Tap CLR to exit.
9
Run Service Menu, Save Cfg, to store the new setting.
10
Service Menu, LCP-632
By default, each LCP-632 that you connect to the KP-632 takes control of level adjustment for the
first available group of 16 physical keys that it finds. The first LCP-632 adjusts keys 1-12, which
corresponds to the bottom row of keys on the KP-632; the second LCP-632 adjusts keys 13-24,
and so forth (Figure 6.1). If you do not want to use an LCP-632 with certain keys, you must
program the KP-632 to skip those keys.
LCP-32 correspondance to KP-32 and EKP-32
Figure 6.1
For example, you may not want to use LCP-632s with the KP-632 but do want to use them with
an EKP-632. In this case, you must turn off LCP usage for keys 1-24 as follows:
Select
, then tap PGM.
1
LCP-632
displays. This indicates that the first connected LCP-632 will attach to keys 1-12.
2
1-12: Yes
Tap PGM.
3
displays. This indicates that the first connected LCP-632 will skip keys 1-12 and
4
1-12: Skip
will attach to the next available row of keys.
Tap ↓↓ to display
5
6
Tap PGM.
controls the LCD on the EKP-632. Normally the LCD
EXP1
.
13-24: Yes
selection controls the
All
Main
was selected
Main
Left
and
selections.
Left
Right
6-13
selection controls
,
, and
All
Main
will appear. If
EXP1