Switch 4: Call Flash Timeout; Switch 5: Footswitch Enable / Disable; Switch 6: Network Mode Selection; Switch 7: Test/Debug - RTS EKP-632 User Manual

Switch 4: Call Flash Timeout

Default setting = Open: 15 Second Flash.
Description: Whenever there is an incoming call and there is a talk key assigned to the caller, the
talk LED next to that key will flash. The flash can be set for 15 second timeout, or until the
caller's talk key is released.
Future versions of ADAMedit and ZEUSedit will be able to override the Call Flash Timeout
Note
setting.

Switch 5: Footswitch Enable / Disable*

Default = Open: Disabled.
Description: The optional Connector Module has a footswitch (GRP CALL) input. If the
footswitch is enabled (DIP switch 5 set to the "Closed" position), then keys that are latched on
will not activate until the footswitch is closed. Latched keys are indicated by winking green talk
LEDs (on time less than off time), and when the footswitch is activated, the LEDs provide the
normal talk-on indication.
If the talk key is held down in Footswitch mode the channel will be activated until the user
1
Notes
releases the key. The use of this function does not require the footswitch to be used.
If DIP switch 1 is set to the "Closed" position, nothing will latch.
2
Individual keys can be set to non-latching via ADAM Edit. If this is done, the footswitch has
3
no effect on the keys that have been set to non-latching. Please see ADAM Edit help for more
information.

Switch 6: Network Mode Selection

Default Setting: Open (Mode 1)
Description: In the Mode 1 setting, the keypanel functions operate as called out in the main
portion of this manual. If the switch is closed (Mode 2), then the functions operate as outlined in
this manual with slight modifications. Any function that is affected by Mode 2 operation will
have an asterisk (*) by it. The changes/modifications to the functionality is called out in the
section titled "Mode 2 Operation"

Switch 7: Test/Debug

Default Setting: Open.

Switch 8: Test/Debug

Default Setting: Open.

Address Switch Setting

General Information

In Zeus, ADAM CS, and ADAM Intercom Systems, intercom ports are arranged in groups of
eight. All ports in a group share a common data port. Each KP-632 keypanel is uniquely identified
on the data port by the setting of its Address switch. The method of determining the proper
Address switch setting varies for each intercom system. Use the method for your intercom system
as described below. Then set the white pointer on the Address switch to point to the correct
setting.
2-2
K P - 6 3 2 U s e r M a n u a l