RTS EKP-632 User Manual page 92

Configure the RVON-1 from the KP-812
TOP LEVEL MENU, SERVICE, RVON SETUP
Set the IP Address from the Service Level Menu
The RVON-1 card, when shipped has a default IP Address already configured. This must be changed
in order for the RVON-1 card to function properly because the pre-configured IP Address may not
work with your network.
To set the IP Address, do the following:
1. On the KP-812, scroll to Menu.
The top level menu appears .
2. Using the encoder knob, scroll to Service.
3. Tap the encoder knob.
The Service menu appears.
4. Using the encoder knob, scroll to RVON Setup.
5. Tap the encoder knob.
The IP Address menu item appears.
6. Tap the encoder knob.
The actual IP Address appears.
7. Enter the first number in the IP Address.
This activates the first octet of the IP Address and clears the rest of the IP Address.
8. Tap the encoder knob.
This confirms the first octet in the IP Address and moves you to the second octet.
NOTE: Tap the encoder knob to skip over any octet that does not need modifications.
9. Repeat steps 7 and 8 until the entire IP Address is entered.
10. Tap the encoder knob.
The Netmask menu item appears .
NOTE: Once you have entered the IP Address, you will then enter the Netmask. The Netmask is a
string of number similar to an IP Address, except that it masks or screens out the network
part of an IP Address so that only the host computer part of the address remains
(for example, 255.255.255.0).
11. Tap the encoder knob.
The actual Netmask appears.
12. Enter the first number in the Netmask.
This activates the first octet of the Netmask and clears the rest of the Netmask.
13. Tap the encoder knob.
This confirms the first octet in the Netmask and moves you to the second octet.
NOTE: Tap the encoder knob to skip over any octet that does not need modifications.
14. Repeat steps 13 and 14 until the entire Netmask is entered.
15. Tap the encoder knob.
The Gateway IP Address menu item appears.
14 RVON-1 User Manual