Configure The Rvon-8 Using Azedit To Contact The Rvon-1 - RTS EKP-632 User Manual

Configure the RVON-8 using AZedit to contact the RVON-1

To configure the RVON-1 card, do the following:
1. From the Status menu, select I/O Cards.
The I/O Card Status screen appears showing the types of installed cards .
2. Right click on an RVON-8 card and select RVON-8 Configuration.
The RVON-8 Configuration screen appears .
NOTE: The RVON-8 you use should be already configured. If it is not configured, refer to your
RVON-8 Card User Manual.
Remember, the RVON-1 has only one channel that can be configured.
3. In the RVON-8 Channel drop down list, select the channel that will be used to communicate
to the RVON-1 card across the network.
4. In the Device IP field, enter the IP Address for the RVON-1 card.
5. From the Device Type drop down list, select RVON-1/Keypanel.
16 RVON-1 User Manual