Rvon-1 Relay - RTS EKP-632 User Manual

To install the RVON-1 card into the KP-812 keypanel, do the following:
1. Remove the cover from the KP-812 keypanel.
2. Mount the supplied spacers (there are three) on the RVON-1 card. See figure 4.
4. Securely connect the RVON-1 card to the KP-812 mother board, see figure 6 for connector specifics.
5. Using a screwdriver, attach the Ethernet connector cable mount to the backplane on the KP-812. See
Figure 2.
6. Connect the Ethernet connector to the RVON-1 card, see figure 4.
7. Replace the cover on the keypanel.
90-240 V AC MIC OUT
Figure 5. The KP-812 series Ethernet knockout placement.
In the KP-32 keypanel, the RVON-1 card connects to the KP-32 by way of the J2 connector on the RVON-1
attached to J4 on the KP-32 header. Gently secure the board in place. See Figure 6.
Figure 6. The J4 connector on the KP-32 board.
In the KP-812, the RVON-1 card connects to the KP-812 by way of the J2 connector on the RVON-1
attached to J37 on the KP-812 header. Gently secure the board in place. See Figure 7.
NOTE: Be sure the orientation of the board is correct, otherwise undesirable effects may occur. Make sure
the RJ-45 connection is positioned so it will fit through the specified knockout on the back cover. When
installing the RVON-1 card in an existing KP-32 or KP-812, each keypanel needs to be upgraded to include
the following:
KP-32
•
A backplate that allows for the RJ-45 connection (Ethernet).
•
Larger flash chips.
KP-812
•
A backplate that allows for the RJ-45 connection (Ethernet).
•
Extension for the RJ-45 connector.

RVON-1 Relay

When connected to an Ethernet LAN, audio comes from the RVON 1 card; and, when Ethernet is not
plugged in, the audio comes from the AIO connection. Note, the user does not need to remove the RVON-
1 card to switch to AIO mode.
WARNING!: You cannot have both an Ethernet connection and an AIO connection simultaneously. If the
Ethernet and AIO are connected simultaneously, no audio communication will occur.
RVON-1 User Manual
Desktop version
Rackmount version
knockout
MIC IN SPK MON AUX IN
HEADSET
H-MIC G-MIC
FOOT SW/SPEAKER
knockout
RELAY 1&2 A RELAY 1&2 B
FRAME
EXP LCP OPT. 1&2 OPT. 3&4
Figure 7. The J37 connector on the KP-812 board.
COAX
11