Basic Operation; Screen Saver Operation; Selecting Headset Or Speaker; Listen Volume Adjustments - RTS EKP-632 User Manual

Screen Saver Operation

If the KP-632 is set for screen saver operation, the alphanumeric display automatically shuts off
after several minutes of inactivity. The display reactivates on incoming call or when the keypanel
operator actuates any control. DIP switch 3 turns enables/disables screen saver operation.
You can override the normal timeout period for screen saver operation and immediately place the
Note
keypanel in screen saver mode. See "Service Menu, Disply Dim".

Selecting Headset or Speaker

Tap the Headset / Vol. Sel. key downward. The Vol. Sel. display alternates between
Speaker
the speaker is selected.
Future versions of ADAM Edit and Zeus Edit will be able to override the Headset or Speaker
Note
setting.

Listen Volume Adjustments

By default, the Vol. control adjusts the listen volume for the speaker or headset, whichever
appears in the Vol. Sel. display. The level of auxiliary program inputs 1 & 2 (if GPI/O board is
present and Aux inputs are enabled) and the level of incoming audio from the intercom matrix can
be adjusted. To adjust a level, press the Vol. Sel. button until the desired source appears in the
Vol. Sel. display (
Vol. control defaults back to the speaker or headset after about one minute of inactivity of the
control. The minimum volume level for either the keypanel speaker or headset may be adjusted.
See "Service Menu, Min Volume".
You can save the volume adjustments to be the power-up defaults using "Service Menu, Save
Note
Cfg".
with each key tap. The Headset LED lights when the headset is selected and is off when
or
Aux1, Aux2,
B
C 3
HAPTER
). Then, use the Vol. control to adjust the listen volume. The
Icom
S
E C T I O N
O
ASIC PERATION
3-1
3
and
Headset