Key Option Menu, Solo
A solo key will cause all other keys to turn off when activated. You can assign one solo key.
Select
1
2
Tap Key
Tap a key. Both LEDs for the key will light red to confirm the assignment. Tap the key again if
3
you made a mistake and want to remove the assignment.
Tap CLR when finished.
4
Activating the solo key should now cause all other activated keys to turn off. The keys will turn
5
back on again when you turn off the solo key.
Run Service Menu, Save Cfg, to store the Solo setting.
6
The solo option will continue on a key even if you change the key assignment.
Note
Removing the solo key option
1
Select
The LEDs for the solo key will be lit red.
2
Tap the solo key to turn off the LEDs.
3
Tap CLR to exit.
4
The solo key is now cleared.
5
6
Run Service Menu, Save Cfg, to save the change.
SERVICE MENU
Service Menu, Aux Inputs
Enables or disables an AUX input audio path to any outputs.
Select
1
Aux In 1 displays. To select Aux In 1 or 2, press ↓↓ .
2
Tap PGM.
3
→
4
Enabled
is enabled.
Tap PGM
5
Tap CLR to exit when finished
6
The new Aux In assignment is now set.
7
Run Service Menu, Save Cfg, to store the Aux Inputs setting.
8
To assign the destination of the Aux Inputs, see the Mixing entry for "Service Menu, DSP
9
Func".
Service Menu, Dim
This item causes the speaker or headphone level to diminish by a specified amount whenever a
talk key is activated.
then tap PGM.
Solo
displays.
, then tap PGM.
Solo
, then tap PGM.
Aux Inputs
displays.To select enabled or disabled, press ↓↓. The arrow indicates that the input
6-9