Ip Setup - ZyXEL Communications ZyXEL Dimension ES-3024 User Manual

Dimension ES-3024 Ethernet Switch
LABEL
Monitor When the Monitor Interval time period expires, each port begins counting
Interval broadcast frames allowed in its buffers anew. Select a time period from 64, 1024,
8000, 256000 microseconds from the drop-down list box.
Direction Choose to monitor broadcast packets coming into the switch (Incoming) or going
out of the switch (Outgoing).
Link Select this checkbox to enable Link Aggregation Control Protocol (LACP). See
Aggregation the Trunk Setup chapter for more information on LACP.
Control
Protocol
System LACP system priority is a number between 1 and 65,355. The switch with the
Priority lowest system priority (and lowest port number if system priority is the same)
becomes the LACP "server". The LACP "server" controls the operation of LACP
setup. Enter a number to set the priority of an active port using Link Aggregate
Control Protocol (LACP). The smaller the number, the higher the priority level.
802.1x Select this checkbox to permit 802.1x authentication on the switch. You must first
Authentication allow 802.1x authentication on the switch before configuring it on each port.
Click Apply to save your changes back to the switch or click Cancel to begin configuring this screen afresh.

5.9 IP Setup

The switch needs an IP address for it to be managed over the network. The factory default IP address is
192.168.1.1. The subnet mask specifies the network number portion of an IP address. The factory default subnet
mask is 255.255.255.0. The default gateway specifies the IP address of the default gateway (next hop) for
outgoing traffic. 0.0.0.0 means no default gateway is specified.
Click IP Setup in the navigation panel to open this screen.
5-8
Table 5-4 Switch Setup
DESCRIPTION EXAMPLE
65535
General, Switch and IP Setup