ZyXEL Communications ZyXEL Dimension ES-3024 User Manual page 133

socket
cpu
snmp
Commands Introduction
Table 21-1 command summary
COMMAND
pktcnt <port>
pktcntclear <port>
port <portID> <enable | disable>
<Speed> <FlowCtrl>
phyread <portID> [<phyAddr>]
phywrite <portID> <phyAddr>
<data>
dbm mac cnt [port]
Dbm mac list [port]
Dbm mac search <MAC> <VID>
log level [0-4]
log switch on/off
log list
Log module <module_id> <on/off
log switch < on|off >
memdum <start_addr> <length>
wreg <addr> <value>
rreg <addr>
show_int_count
clear_int_count
display
getCommunity [<community>]
Dimension ES-3024 Ethernet Switch
DESCRIPTION
Display port statistic counter
Reset port statistic counter
Port setup
Read PHY register
Write PHY register
Display number in L2 DBM
Display entries in L2 DBM
Search the MAC/VID learnt on
which port.
Sets the log level. Logs displayed
consist of critical, error, warning,
debug and informational
messages in order of severity. Log
level "4" displays all messages; log
level "0" just displays critical
messages.
Outputs messages to the console
or telnet screen.
Lists all IXE log modules.
Enable / disable log on specific
IXE module
Log all modules to tracelog.
(Current display to console
directly)
Displays the switch chip's memory
map for the block specified.
Writes to a register.
Reads from a register.
Displays the interrupt counter.
Resets the interrupt counter.
Displays the system socket's ID #,
type, control block address (PCB),
IP address and port number of
peer device connected to the
socket (Remote Socket) and task
control block (Owner).
Displays the CPU's utilization.
Sets or displays the SNMP
GetRequest community.
21-5