Single-port power over ethernet injector; 8-port power over ethernet hub (2 pages)
Summary of Contents for ZyXEL Communications ES-2024PWR
Page 1
Ethernet Switch ZyNOS 4.00 Support Notes Version 4.00 October 2011...
Page 2
• Flexible access point location –Wireless access points no longer need to be located near AC power source or need power lines and outlets. • Remote management – IP phone, WLAN access points can be powered up or down remotely. All contents copyright (c) 2011 ZyXEL Communications Corporation.
Page 3
Power is carried over the data pairs (1/2 & 3/6) Alternative B is also called “MidSpan” which means that data and power are NOT in the same twisted pairs. Power is carried over the spare pairs (4/5 & 7/8) All contents copyright (c) 2011 ZyXEL Communications Corporation.
Page 4
PoE Support Note Our PoE Our products (switch & injector) which support IEEE 802.3af-2003: ES-2024PWR, ES-2108PWR, ES-3124PWR, GS1500-24P, GS2200-24P, PoE-10, PoE-12, PoE-80. Our products (switch & injector) which support IEEE 802.3at-2009: GS2200-8HP (only port 1~4 have HP), PoE12-HP. Scenario We connect PoE-enabled devices to our switch (GS2200-8HP), and then we proceed to set up PoE on the switch.
Page 5
1. Click Basic Setting > PoE Setup in the navigation panel to display the screen as shown below. Use this screen to configure PoE settings. 2. You can choose the PoE mode (GS2200-8HP only has consumption mode) and enable PD & PD priority. All contents copyright (c) 2011 ZyXEL Communications Corporation.
Page 6
PoE Support Note 3. After configuring PoE settings we need to use CLI to enable PoE on the port-interface. All contents copyright (c) 2011 ZyXEL Communications Corporation.
1. Enable PoE on port interface and set usage threshold and MIB traps. sysname# configure sysname(config)# pwr interface 1-4 sysname(config)# pwr usagethreshold 25 sysname(config)# pwr mibtrap sysname(config)# exit 2. Check the PoE status in CLI GS2200# sh pwr All contents copyright (c) 2011 ZyXEL Communications Corporation.