Dynamic Link Aggregation; Authentication; Switch Setup Screen - ZyXEL Communications ZyXEL Dimension ES-3024 User Manual

Dimension ES-3024 Ethernet Switch
PORT STATE
Learning All BPDUs are received and processed. Information frames are submitted to the learning
process but not forwarded.
Forwarding All BPDUs are received and processed. All information frames are received and forwarded.

5.6 Dynamic Link Aggregation

The ES-3024 supports the link aggregation IEEE802.3ad standard. This standard describes the Link Aggregate
Control Protocol (LACP), which is a protocol that dynamically creates and manages trunk groups.
When you enable LACP link aggregation on a port, the port can automatically negotiate with the ports at the
remote end of a link to establish trunk groups. LACP also allows port redundancy, that is, if an operational port
fails, then one of the "standby" ports become operational without user intervention
Please note that:
You must connect all ports point-to-point to the same Ethernet switch and configure the ports for LACP
trunking.
LACP only works on full-duplex links.
All ports in the same trunk group must have the same media type, speed, duplex mode and flow control
settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
5.7 802.1X Authentication
See the Port Setup chapter for more information on 802.1x authentication.

5.8 Switch Setup Screen

Click Switch Setup in the navigation panel to open the Switch Setup screen. The VLAN Setup screen changes
depending on whether you choose 802.1Q VLAN Type or Port Based VLAN Type in this screen.
5-4
Table 5-3 STP Port States
DESCRIPTION
General, Switch and IP Setup