Config Save - ZyXEL Communications ZyXEL Dimension ES-3024 User Manual

Dimension ES-3024 Ethernet Switch
traceroute
igmpsnoop
config save
The following commands are system switch commands; all are preceded with
garp status
timer
gvrp status
enable
disable
qos defpri
map
vlan1q
port
21-8
Table 21-1 command summary
COMMAND
<host> [ttl] [wait] [queries]
status
querier
enable
disable
COMMAND
<join timer(ms)><leave
timer(ms)><leave all timer<ms>
<port> [<0..7>]
<0..7> [<queue>]
status <port>
defaultvid <port><vid>
accept <port> <all|tagged>
DESCRIPTION
Sends ICMP packets to trace the
route of a remote host.
Displays the IGMP group table.
Displays the port number of the
incoming port that received the
latest IGMP querier.
Turns on IGMP snooping.
Turns off IGMP snooping.
This command stores tagged IEEE
802.1Q VLAN and STP
configurations only in nonvolatile
memory. All other command
configurations are lost when you
restart the switch.
.
sys sw
DESCRIPTION
Shows the GARP timer status.
Sets the GARP timer's Join
Timer, Leave Timer and Leave
All Timer.
Shows whether GVRP is
enabled or not.
Enables GVRP.
Disables GVRP.
Sets the default ingress User
Priority for a port.
Maps a User Priority to a Traffic
Class.
All "sys sw vlan1q" commands
relate to IEEE 802.1Q Tagged
VLAN configuration. Use "config
save" to save your configuration
changes.
Shows a port's VLAN
information.
Sets the default VLAN ID of a
port.
Sets the type of frames that a
port accepts.
Commands Introduction