Ex9200-6Qs Line Card - Juniper EX9214 Hardware Manual

1 Ejector lever
—
Line card LED
2
—
3 MIC LED
—
You can use the
show version
the switch.
Line Card Components
The EX9200-4QS line card has:
• Four 40-Gigabit Ethernet ports, each of which can house QSFP+ transceivers.
• Four dust covers preinstalled in the ports.
• Line card LED—An LED labeled OK/FAIL, which indicates the status of the line card. See
LED in an EX9200 Switch
• MIC LED—An LED labeled OK/FAIL on each MIC, which indicates the status of the MIC. See
Modular Interface Card LED in an EX9200 Switch
• LEDs for the ports—One LED on each port, the Link/Activity LED, which indicates the link status and
activity on the port. See

EX9200-6QS Line Card

IN THIS SECTION
Line Card Models | 88
Line Card Components | 88
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces in a
single assembly. Line cards are field-replaceable units (FRUs) that you can install in the line card slots on
the front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and
replace them without powering off the switch or disrupting switch functions.
command to see the version of Junos OS for EX Series switches loaded on
.
.
Network Port LEDs on Line Cards in an EX9200 Switch
4 LEDs for the ports
—
40-Gigabit Ethernet ports
5
—
Line Card
.
87