Installing The Cable Management Bracket In An Ex9214 Switch - Juniper EX9214 Hardware Manual

Installing the Cable Management Bracket in an EX9214 Switch

Before you install a cable management bracket in the switch:
• Ensure you understand how to prevent Electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage
Ensure that you have the following parts and tools available:
• ESD grounding strap
• 7/16 in. (11 mm) nut driver
You can install the cable management bracket below the line card and SF module slots on the front
panel.
To install the cable management bracket:
1. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD point on the
chassis.
2. Position the cable management bracket on the studs on the lower part of the front panel. See
92 on page 282.
3. Insert the nuts on the corners in the cable management bracket into the studs on the chassis.
.
Prevention of
Figure
281