Ex9200-40Xs Line Card - Juniper EX9214 Hardware Manual

EX9200-40XS Line Card

IN THIS SECTION
Line Card Models | 107
Line Card Components | 108
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces in a
single assembly. Line cards are field-replaceable units (FRUs) that you can install in the line card slots on
the front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and
replace them without powering off the switch or disrupting switch functions.
Line Card Models
Table 38 on page 107 shows the model number, description of the line card model, and the Junos OS
release in which the line card was first supported.
Table 38: EX9200-40XS Line Card
Model Description
EX9200-40XS A line card with 40 10-Gigabit Ethernet ports with Media Access
Control Security (MACsec) capability, each of which can house 10-
gigabit small form-factor pluggable plus (SFP+) transceivers. The
EX9200-40XS line card supports 802.1AE IEEE MAC Security
standard (also known as MACsec) with AES-128 bit encryption
and AES-256 bit encryption, providing support for link-layer data
confidentiality, data integrity, and data origin authentication. You
must apply a single license—EX9200-SFL—to enable MACsec.
NOTE: For the EX9200-40XS line card to be operational, you must install the EX9200-SF2 Switch Fabric module
(SF module) in the switch. See
EX9200 Switch .
Switch Fabric Module in an EX9200 Switch
Junos OS Release Required
16.1R1 or later
and Installing an SF Module in an
107