Power Requirements For Ex9200 Switch Components - Juniper EX9214 Hardware Manual

Table 19: DC Power Supply LEDs in EX9214 Switches
Feed Description
Mode
Two- The power input to the INP-0 DC
Feed power inlet located on the power
supply is connected and the power
input to the INP-1 DC power inlet
located on the power supply is not
connected; the input is within the
acceptable range, but the power
supply is functioning normally and is
not providing power to the switch
chassis.
The power input to the INP-1 DC
power inlet located on the power
supply is connected and the power
input to the INP-0 DC power inlet
located on the power supply is not
connected; the input is within the
acceptable range, but the power
supply is not functioning normally
and is not providing power to the
switch chassis.
The power inputs to the INP-0 and
INP-1 DC power inlets located on
the power supply are connected; the
inputs are within the acceptable
ranges and the power supply is
functioning normally and providing
power to the switch chassis.

Power Requirements for EX9200 Switch Components

Table 20 on page 58 lists the power requirements for different hardware components of EX9200
switches.
(Continued)
LEDs
INP0 OK INP1 OK
Green Off
Off Green
Green Green
DC OK PS FAIL
Off Red
Off Red
Green Off
57