Install A Transceiver - Juniper EX9214 Hardware Manual

CAUTION: To prevent ESD damage to the transceiver, do not touch the connector
pins at the end of the transceiver.
Figure 86: Remove a QSFP+ Transceiver
Ejector lever
1
—
To remove a CFP transceiver:
a. Using your fingers, loosen the screws on the transceiver.
b. Grasp the screws on the transceiver and gently slide the transceiver approximately 0.5 in. (1.3 cm)
straight out of the port.
CAUTION: To prevent ESD damage to the transceiver, do not touch the connector
pins at the end of the transceiver.
7. Using your fingers, grasp the body of the transceiver and pull it straight out of the port.
8. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
9. Place the dust cover over the empty port, or install the replacement transceiver.

Install a Transceiver

Before you install a transceiver in a device, ensure that you have taken the necessary precautions for
safe handling of lasers (see
Ensure that you have a rubber safety cap available to cover the transceiver.
Laser and LED Safety Guidelines and Warnings
).
268