Ex9200-32Xs Line Card - Juniper EX9214 Hardware Manual

• When a network port is configured for 4 x 10GbE channelized interfaces with a breakout cable.
• When a network port is configured for 4 x 25GbE channelized interfaces with a breakout cable.
Cables and Connectors
You can use the Hardware Compatibility Tool
supported on your Juniper Networks device.
The list of supported transceivers for the EX Series is located at

EX9200-32XS Line Card

IN THIS SECTION
Line Card Models | 100
Line Card Components | 101
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces on a
single assembly. They are field-replaceable units (FRUs) that you can install in the line card slots on the
front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and replace
them without powering off the switch or disrupting switch functions.
Line Card Models
Table 34 on page 100 shows the model number, description of the line card model, and the Junos OS
release in which the line card was first supported.
Table 34: EX9200-32XS Line Card
Model Description
EX9200-32XS A line card with 32 10-Gigabit Ethernet ports, each of which can
house 10-gigabit small form-factor pluggable plus (SFP+)
transceivers
to find information about the pluggable transceivers
EX Series Supported Transceivers.
Junos OS Release
Required
12.3R2 or later
100